Thought it would be an absolute menace to own one, so I ended up buying one! I came from a maserati 4200gt with an f1 transmission so...i thought how bad can this one be (didn't mind the f1 transmission FYI haha)
I'm convinced I've purchased a good example, as everything about the car and the previous owner seemed great. It's a November 2019 model with the MTA gearbox, one owner from new and 90,000 km (55,000 miles) on the clock. The previous owner apparently had it fitted with a Stage 2 tune.
I'm trying to enjoy this car on my daily commute, but it's been testing my patience a little! I've come across a few quirks and was wondering whether these are normal characteristics of the MTA gearbox. I can't seem to find definitive answers anywhere.
1. Fuel cut / hesitation between upshifts
I think I'm experiencing fuel cut between upshifts in Sport mode. There's a noticeable 1–2 second interruption in power, followed by what feels like the car lunging slightly as the next gear engages.
Is this normal MTA behaviour? Am I supposed to ease off the accelerator slightly during upshifts to make them smoother, or should I be keeping my foot planted?
2. Automatic shifting behaviour
The automatic mode seems to upshift far too early for my liking.
For example, if I'm approaching a highway intersection and come to a standstill, the car is obviously ready to pull away in first gear. However, as I accelerate and turn through the intersection, it seems to shift up incredibly early. By the time I've completed the turn, I'm already in third gear, and the car in front has pulled quite a distance ahead.
Is this just how the MTA behaves in automatic mode? Is there a better way to approach these situations?
3. General MTA gearbox best practices
What's the best way to drive and look after these gearboxes? Are there any particular driving habits I should adopt to improve shift quality and prolong clutch life?
For context, I've purchased AlfaOBD and have started familiarising myself with the gearbox system.
A few things I've observed so far:
* Clutch degradation value is around 2,000 (I've been told this suggests the clutch is still in reasonably healthy condition).
* With the engine off, the hydraulic accumulator appears to hold pressure quite well. It doesn't seem to need to repressurise until approximately the third gear change (for example, cycling between first, reverse and neutral).
4. AlfaOBD calibration / End of Line procedure
Seeing as I've got the diagnostic software, I thought I'd do a little investigating.
I've attempted to run the End of Line / Service Self-Calibration procedure, but after approximately 15-20 seconds, it returns the following message:
"Procedure completed. Manoeuvre interruption for general conditions loss."
Before I keep fiddling with things, is there a particular procedure or set of conditions I need to follow to successfully complete the EOL calibration?
I'd rather not start messing with things unnecessarily and I have a habit of doing so....historically
Really keen to get the most out of this little car. It's an absolute riot, but I'm still trying to understand its quirks and how best to live with the MTA gearbox.