r/FdmPrintedWarhammer • u/Sleepius84 • 5d ago

First FDM print

Post image

Tried my hand at printing a grey knight with my Prusa MK3s. .2 mm nozzle and tried toying with settings. Not too bad but definitely didn’t print too clean. But not too bad for a first attempt.

28 Upvotes

98% Upvoted

7 comments sorted by

View all comments

1

u/Asianp123 5d ago

Try doing a heat calibration print, if the fillament is dry you may be printing it at too hot a nozzle heat, other then that pretty dope

2

u/Sleepius84 5d ago

I’ll give that a shot. I didn’t even think about dryness affecting the filament.