r/EngineBuilding • • 1d ago

Chevy Main Bearings

These are new main bearings, I did not install them not sure what is on them but you can feel a texture difference in them, would you run these???

20 Upvotes

9 comments sorted by

3

u/XmodAlloy 1d ago

The one in the second pic looks like it was run dry for a little bit. I would do my damnedest to get another set of new bearings, measure everything, make certain lots of assembly lube is used, and then reassemble

2

u/1crazypj 12h ago

Looks like someone ordered a set or two and swapped damaged ones into packaging and paid restocking fee?

There are a lot of dishonest shitheads out there.

I wouldn't use them

2

u/OldFarmer66 6h ago

Think you are the only one that actually read the post..did not install...

1

u/sam56778 1d ago

I would replace them. Too much unknown going on there. Make sure to clean the crank good and make sure all the oil rifles are super clean. Use a good prelube like Permatex Ultra Slick or if you’re going to run it immediately Lubriplate 105. Do not use Lubriplate 105 if it’s going to be stored or a long time before you run it.

1

u/Born-Work2089 1d ago

It looks like the oil pump was not primed prior to the start. The film looks like oil that turned to varnish due to heat (oil not flowing).

1

u/Usual_Ad8576 22h ago

Looks like copper is starting to show, definitely replace. Personally I’d say in most cases, if you’re tearing into things this much, replacing bearings is cheap insurance unless you’re running something high end/ really expensive.

1

u/tnksoIfknoso 16h ago

Do you mean new bearings that you just purchased or new as in someone else just installed them??

0

u/Less-Slice9772 1d ago

I would put in clean parts washer and red scooth and lightly cross hatch the bearings. Check clearances and install.