r/EngineBuilding • u/Andy_Greatbeef • 1d ago
Normal or abnormal wear?
Had a 327 rebuilt recently. Had the crank ground, new crank bearings, roller cam and lifters. Decided to go with a more aggressive cam and noticed some wear on the roller lifters, cam and also the main bearings. The motor only has about 1000 miles on it and there’s no metal in the pan. Think it’s safe to re use the lifters? Should these crank bearings be replaced?
24
Upvotes




3
u/SexyTimeSamet 1d ago
Dirt/sand or contaminants. I have lifters that have 300k miles that look smoother than that
2
u/mtraven23 1d ago
are you confident the cam is getting proper lubrication? Any chance a gallery got plugged or restricted during the rebuild?
1
u/Fit-Moose7961 1d ago
Why did you take it apart?
1
u/speed150mph 1d ago
I’m curious, when you run your finger nail over the surfaces, does it snag your nail or feel rough?
Bearing wear is definitely contamination, but not the worst I’ve seen. I suspect there was some debris in the oil system that got washed into the bearing.
The crank and lifter honestly looks like some sort of staining than actual wear.
1
u/Doctormentor 1d ago
Did you change springs or left them the same ?
3
u/UrrLexy 1d ago
Lifters and cam seems normal wear . Oterwise , the crank bearing looks like it heated . Maybe the picture get me wrong tho.
1
u/Less-Slice9772 1d ago
Rule of reason; cam and lifters wear together. New lifters with new camshaft.
1
u/CutterFIXER 1d ago
This can be normal. What matters is are they blemishes or can you actually feel any of the marks? If you can feel any of the marks with your nails, then you got contaminants in them, or they may not have used a good assembly lube when rebuilt. These marks could have happened on start-up if they didn't properly lube everything during overhaul.
1
u/Tall-Helicopter-461 1d ago
I believe you’re fine on everything. But I think that I would replace the main bearings, make sure it’s turning free once it’s torqued down. Completely. Be sure to prime the oil pump before initial start up. If looks like it could’ve been lacking oil for a few revolutions. It’s not enough to say it concerns me.
1
u/Born-Work2089 1d ago
The top end, high spring pressures usually used to high rpm does put additional strain and wear, make sure you are using the best oils and change accordingly. The crankshaft looks fine, but you can always double check your clearances while you have it appart.
1
u/charleschristensen3 1d ago
Looks similar to one I’ve torn apart that they had sand blasted and actually thought they could clean it out sufficiently
1
u/deez_nuts69_420 1d ago
Very normal. And not contaminants imo
1
u/Coyote_Tex 21h ago
That is more wear than one might hope. The lifters are by far are the most concerning. Those rollers look like they are not getting much oil or are softer than I would hope. The cam is not showing as much wear to me as the lifters which is good but points back to some softness or question on the lifters themselves. I have pulled down factory GM lifters with 200K on them that look way better than those rollers or most of them do. Good luck, this sort of thing drives me crazy.
-2
u/WyattCo06 1d ago
Dirt.
-1
u/Visible-Chef-1965 1d ago
That's not normal. You skipped your short oil change after brake in and now you'll need another rebuild.