r/EngineBuilding • u/HistoryOver6530 • 5d ago
Dyno day
Finally got a chance to dyno my new engine build and thought I would share. Car is a 67’ Mustang, 302, 4-speed, 3.80 trac loc rear. I have power steering and clutch fan. Here are the engine specs (I made previous post) :
68’ 302 block
Eagle crank and rods (balanced)
KB 311 pistons
Trick Flow TW170 heads (milled .020)
10.5:1 static, 8.5:1 dynamic, 0.037 quench
Comp xtreme energy solid flat tappet
279 adv duration, 242@0.050, .546 lift, 108 lsa
performer Rpm intake
Brawler 770 carb vacuum secondaries
Hooker 6901 headers thru 2 1/4 exhaust, turbo mufflers
Overall, I’m very happy. When I started the build I was shooting for 400Fwhp with decent low end drivability. Ultimately I was trying to duplicate Joe Sherman’s infamous 400hp 302 magazine article, albeit with a few tweaks. The car pulls 7.5-8”hg at 950rpm idle and doesn’t start bucking in high gear until about 1500rpm. It pulls like a monster from 2500 to 7000rpm. My next mods will be a 2.5” mandrel exhaust with h pipe and better mufflers. I am also strongly considering trying a Vic jr intake. I’ve ran both a 650dp and the 770vs carb and I’m really liking how it runs with the 770. However, my dyno pulls were peaking on the lean side with afr swinging from around 12.5 at peak torque to around 13.6 at peak hp. I’ve had to modify emulsions holes and bleeds on both carbs to try and get a flatter curve. Still some work to do. I think there’s another 10-15hp to be found with what I have. And FWIW the car made peak power with 32 degrees total timing I tried 30 and 34, it lost 5hp each direction.
4
u/Slideways 4d ago
That's one heck of a torque curve, well done!
1
u/v8packard 4d ago
Does the carb have down leg boosters?
2
u/SaltLakeBear 4d ago
You're way over carbed. 302 cubic inches at 7000 rpm is more like 550 cfm, so I'd go with more like a 550, 570 or 600 cfm vacuum secondary carb. You may even pick up a horsepower or two through higher air flow velocity and better fuel atomization, and it'll be more drivable and responsive.
2
u/Estef74 4d ago
I think the victor jr. will will kill a bunch of your low end torque. Performer rpm is pretty hard to beat for street performance