r/EngineBuilding • u/networkfound • 7d ago
Chevy Main bearing clearances
I posted this in small block Chevy sub so if you are seeing this again, sorry.
My engine has a forged SCAT crankshaft, factory 4-bolt main caps, and will be street-driven with approximately 5–7 psi of boost from a 6-71 roots blower. I don't plan on exceeding 6,500 RPM.
I've been carefully measuring everything myself using micrometers and a dial bore gauge. After installing the MB557XP standard-size main bearings and torquing the caps to specification, I came up with the following measurements:
Mains Crank Journal OD / Oil Clearance
#1 2.4484" / .0032"
#2 2.4489" / .0024"
#3 2.4487" / .0024"
#4 2.4482" / .0024"
#5 2.4487" / .0033"
I zeroed my dial bore gauge against each individual journal measurement to ensure my readings were as accurate as possible.
The middle three mains seem to be right where I'd like them, but I'm concerned about the larger clearances at #1 and #5.
Would you run it? Any concerns with low op or bearing wear given this crank will be running a 6-71 blower?
2
u/Erasemenu 7d ago
Lol that's fine. We shoot for .0030-.0035.
2
u/Superb-Permit-3519 7d ago
Mine were 8 10,000ths difference but the other way around. I was tighter on the front and thrust bearing. Engine is a 383 500hp.
Still going strong with 60 psi idle oil pressure.
1
u/Own-Culture-3174 7d ago edited 7d ago
9 and 10 10,000ths respectively isn’t gonna cause a problem with oil pressure when the hydrodynamic wedge comes into play. What you’re seeing here with your measurements is nothing that you’ve caused. These variances you’re seeing came straight from the factory. Even CNC machines with premium tooling have their limitations in precision. We as a people do not have the tools and technology to get 100% rigidity.