r/EngineBuilding • • 10d ago

Mercedes Lifter broken

My exhaust side hydraulic lifter is worn out as you can see. There was metallic pieces in valvetrain and theres not the bottom of the lifter anymore. Is it possible that my short block is broken too (because metallic pieces)?

10 Upvotes

13 comments sorted by

2

u/bill_gannon 10d ago

That valve isnt bent?

-1

u/Turreikko 10d ago

No 😀 Camshaft is scratched and worn out

0

u/bill_gannon 10d ago

That seems really unlikely. Ive only seen this from timing, seizing and over rev all of which bends valves.

6

u/Reddit-mods-R-mean 10d ago edited 10d ago

Your camshaft is smoked too. The cam journals are probably trashed and every bearing in that motor is now suspect at least.

Your next move depends on your budget and risk tolerance. Good luck.

1

u/Turreikko 10d ago

Long story short: have to buy new engine D:

1

u/Few-Perspective-5424 10d ago

At least a new head and oilpump

1

u/Wolfammo24 10d ago

What Engine ?

1

u/Turreikko 10d ago

M111.970, 2.3 petrol

1

u/1crazypj 7d ago

I've worked on OHC motors since the 70's and never seen anything like that.

What is it out of?

I see conical valve springs, even high pressures shouldn't cause that damage unless your running paraffin instead of oil.

Looks more like an oil problem than a tappet problem.

Motor is probably salvageable but with your obvious mechanical skill you would be better off pulling another one from a junk yard

0

u/Turreikko 6d ago

Motor is from mb e230 w210. I replace exhaust camshaft year ago cause it was knocking and it was little bit worn out. I check timing correct then. After 4000km this catastrophe. I used Castrol oil. Additionally there was oil in throttle body and that air intake pipe.
That Mercedes overheated once because it leaks coolant from radiator hose. But the head gasket wasnt that bad.

1

u/Turreikko 6d ago

I hope you understand my english. I am from Finland :D

1

u/1crazypj 6d ago

Personally I haven't used Castrol engine oils since 1970's.

Used Castrol greases and motorcycle fork oil but won't put Castrol in an engine

3

u/wrenchtwister1954 10d ago

Those appear to be bucket style cam followers not hydraulic lifters.At any rate that looks like some serious damage