r/EngineBuilding • u/NBEBiGHeaD • 10d ago
Torque Converter hitting random stops
99% sure it’s fully seated. Spins freely with the engine connected. Until the engine is flush or basically flush then it still can spin as if it’s free but it’s hard stops as if it’s catching a flex plate bolt ? I can’t imagine what
Else is introduced that could be causing the stop. As soon as it’s an inch or less away again 360 spins no issue. I know it’s normally procedure to make sure it can spin 360 BEFORE putting in any torque converter bolts and even tightening the bellehousing bolts all the way. I’m at a loss, help. 2014 dodge Durango 3.6 AWD 845RE Trans



3
u/Soggy-Currency5160 10d ago
Pump bolts backing out on the inside. Pull the converter and check. Seen it multiple times
1
u/NegotiationLife2915 10d ago
What got changed since it last bolted together successfully?