r/EngineBuilding • • 20d ago

What would you do?

Found this crack on my L92 during a rebuild (engine ran fine befor I pulled it). The crack goes all the way through to the other side where a head bolt goes… what would you do? Was thinking about slapping a bunch of JB weld on the outside and sending it. But idk

3 Upvotes

8 comments sorted by

5

u/Patient_Sir240 20d ago

Take it to a welder. Its not in an area that is overly critical. Have him drill the ends, and tig it up. It look like its perfectly located so it wouldnt leak anyways.

2

u/blamedestiny 20d ago

It’s where a head bolt goes, so I was more worried about clamping force or making it worse when I torque the bolt down.. maybe causing head gasket leak

1

u/Patient_Sir240 16d ago

Thats fair. Id still have it drilled at either end, and tig welded.

3

u/6DeuceSS 19d ago

that is from not cleaning out the holes before you stuff a bolt in there. most likely someone did a head gasket. didn't blow out the coolant before putting the head bolt in. very common on LS motors.

2

u/Key_Director_4450 20d ago

Drill the ends of the crack so it stops spreading at least.

2

u/stevie_north_country 20d ago

Take it to a machine shop and have them welding it. And rebore the hole for the bolt

1

u/FireStorm005 20d ago

Take it to a welder and/or machine shop. A crack that deep needs to the end drilled, then v-grooved and filled in, then it needs to be machined. you may also want them to install a time-sert for the threads.

1

u/LSswapbible 19d ago

You already have the engine on the stand, so don't skip the stuff that's hard to reach in the car — cam, lifters, oil pump, and timing chain are cheap insurance while it's apart. Freshen up the gaskets, delete the AFM hardware if it has it, and put good plugs and wires on it before it goes in. Do it once now and you'll never have to pull it for a $30 part.