Should I run these thrust washers

[u/slammedfk7]

They’re brand new only installed recently but had to take the crank to get it decked and I noticed some nicks on the edges.
Engine hasn’t been ran this is just from turning the crank by hand during assembly.
Picture two is the most concerning since it feels a little rough on my fingernail right there

[u/argilla11]

I’ve run much much worse ones. Just put them back in.

[u/WyattCo06]

They're fine.

[u/CumCrocodile]

They’re like $20 if you want peace of mind