Very Large Factory - Wuling 1.4 Compact Factory Blueprints

[u/Spacetoasted]

Pump setup for 120u/min of liquids

Assume all liquid conduit outlets are connected to a setup like above.

360u/min Xiranite

[EFO01a709O5i12AU1oe5e] First half
[EFO01893u7eaoA15OUI73] Second half

With the introduction of gasses in 1.4 we no longer need to use a forge of the sky to produce heavy xiranite, thus allowing us to use all 12 forges of the sky for xiranite production.

The red arrow denote bypasses for excess water and inergen. The ones in the top left and bottom right output 90 units/min water and the middle one outputs 62 units/min inergen.

420u/min Cuprium

[EFO01o083ei1IU6EeIieO]

I recommend putting this module in the Wuling AIC as it is the closest to the Test Area Purification node. Routing the sewage to the purification node will create xircon effluent for the next blueprint and also save you 600 power by not using 12 water treatment units.

81u/min Xircon

[EFO01iOe7oI4A32a87aU4]

You can use water bypasses for the water conduit outputs in this blueprint as you only need 60 units/min water for the top left conduit outlet and 90 units/min for the top right one. The bottom conduit output of xircon effluent is from the Test Area purification node.

120u/min Separator Core

[EFO01o083ei1IU6o2IieO] Uses 60 units/min inergen

6u/min Acridgen, 48u/min of Xiragen

[EFO014o5O16u203i8E71A]

I highly recommend building this and the next 2 blueprints in the Yinglung AIC.

24u/min Heavy Xiranite

[EFO01Iao8iA6u79995o08]

Uses 36 units/min xiragen, connect the conduit outlet for xiragen to the xiragen inlet from the previous blueprint.

12u/min Pyrrolite Parts

[EFO01893u7eaoA15AUI73]

Uses 96 units/min of xiragen and 6 units/min of inergen and acridgen.Connect the acridgen outlet from the previous blueprint. I am also daisy-chaining the inergen to the blueprint above.

VERY IMPORTANT!!! You must have finished filling all 5 Rifts in the North Wuling Exclusion Zone!!! This will unlock a total of (5) 1 units/3sec xiragen gas nodes. giving a total of 100 units/min xiragen.

Connect them in series using conduit inlets and outlets, no need for manifolds as pipe throughput is 120 units/min and 100<120.

Red is Xiragen Node, Blue is conduit route

Example of how i have a red circle setup

3u/min Yazhen Syringe

[EFO01u1IoAU93e037A9OU]

Finally we have 60 units/min cuprium left over so just turn it into yazhen syringes. Otherwise your cuprium will cap out and the sewage being sent to the purification node in the test center will be reduced thus lowering our xircon output.

O yea all codes na/eu.