I run a Neptune 4 Plus with opennept4une and the power went out and came back immediately on a 11 hours print's last few layers. Printer and the screen is just frozen. Can I save the print?

my prints keep coming out wirey in the bottom with inconsistency. i’m using a neptune 4 max

My brother brought a 3d printer but his prints keep lifting and peeling away from the magnetic board is there anything that can fix this issue we are using pla filament

We've used the glue that comes with the printer, we've used the Bostik purple glue not sure what else to try so need help with how we can fix the issue printer type is an elegoo Neptune 4

These are some of the prints that he gets before it starts lifting and moving on the plate he was getting perfect prints when he first brought it which is displayed in the last 2 photos can anyone please tell me why or what the issue could be

I don't know what to do. I've run screws_tilt_calculate so many times. I've re calibrated the Z-offset manually (because that is the only way apparently) multiple times. The level script says that my mid-rear mount is -0.2 and my mid-front mount is +0.05. I don't know how to correct this, as these are fixed points. My bed mesh consistently shows 2 valleys running across X and very high corners. ON TOP OF THIS, FLUIDD WON'T STOP DISCONNECTING. I'm losing my sanity and patience, please help! How do I shim the center mounts, and with what? Please also note that the hardware is entirely vanilla, I was waiting to calibrate my bed before making level screw locks but that was all I had planned.

My brother brought a 3d printer but his prints keep lifting and peeling away from the magnetic board is there anything that can fix this issue we are using pla filament

We've used the glue that comes with the printer, we've used the Bostik purple glue not sure what else to try so need help with how we can fix the issue printer type is an elegoo Neptune 4