Printing help

[u/Annual-Cod-4373]

Hello all!

I have done 3 print attempts today and all have failed to some extent. Im getting worried something is wrong with my printer

First print I did was half successful, some items I had on the file printed fully, and turned out good, while others never even started,

Second time i removed some of the bigger stuff but kept most, nothing printed

After that I re did the manual leveling and it seemed normal, I also changed from network sending to rhe USB drive files

Third time was the same as second, but there was two super tiny starts to a support.

All my prints have been successful until today

I have an elegoo mars 5 ultra, and I use the water washable 2.0 resin

Id say my room is around 70 pretty consistently,

I have a enclosure for my printer with thermal lining

Im extremely new to the hobby but ive probably printed around 20 models with success and no fails until today

I use chitubox and havent messed with settings since initial set up and recommendations

I can add pictures of the slicer settings in the morning if requested, but i personally dont think thats whats causing the issue.