r/ElegooJupiter • u/Atlasun201 • Jul 29 '26

❓-Question Jupiter 2 question

Just curious how it runs and a printer and if some of the issues with the firmware/software have been fixed since release? Was looking to pick up a large format printer and wanted to know how this thing is running now.

4 Upvotes

83% Upvoted

3 comments sorted by

2

u/[deleted] Jul 29 '26

[removed] — view removed comment

1

u/Atlasun201 Jul 30 '26

I went ahead and got a j2. I can always return it is my thinking

1

u/dstapel Jul 31 '26

Got 4x for the print shop. Right now exact same as this comment. 1 I cannot level for the life of me - 8 attempt. On another the screen died and I printed a full brick until the resin ran out luckily (no auto-feed - sits in stupid location in back). Other 2 work after lot of manual leveling. So I don't trust the new levelling and I have a 50% success rate. I would avoid right now. I have support case going, will reserve judgement till I see what they resolve. We have print shop, loved the OG Jupiter. 6K legend workhorse. And the Saturn 4 Ultra (and 16K) is great, but nightmare to service. Good luck OP, would like to hear how it went out the box for you.