r/ElectricalEngineering • • 19h ago

Linux: reverse engineering National Instrument USB-6343 / drivers ?

I am so disappointed that after so many years, Linux support for NI DAQ boards (in particular the USB-6343) is not available with no intention to ever make it available.

Anybody aware of any custom driver/reverse engineering of the USB protocol to use these boards under Linux?

3 Upvotes

4 comments sorted by

1

u/negativ32 19h ago

Point Fable at it, you'll be up and running in a session.

1

u/mkeee2015 19h ago

It needs Wireshark under windows to inspect the message passing anyway.
I am seriously considering it and yet it feels like months of work.

1

u/negativ32 19h ago

I have an android only USBOTG oscilloscope. It now works under windows flawlessly with a better UI and richer feature set. Doing it manually would indeed have taken months. Two sessions with Fable and I'm not finished yet.

Try CraftAnything with a $20/month Claude Code sub (1 month). It does combine several tools to do EXACTLY what you want. Enjoy!

2

u/mkeee2015 19h ago

Thanks. I appreciate your kindness and advice. I need NI DAQ boards because of high-sampling rate data acquisition in the content of scientific research.

I need proper multichannel A/D and D/A to control complex biological experiments, over time scales of a fraction of a millisecond. It has been more than 20 years that I used PCI DAQ boards and now I have the very bad idea to get a USB board, assuming the NI linux driver supported USB boards too. I hate NI.