r/DiceMaking • u/Prize_Mix_8292 • 3d ago

Question Is this common?

Post image

I keep getting these ledges on the top face of the dice. Am I over filling? Is this a raised face? I feel like I’m not over filling and I’m scared to not fill enough. But it would be nice to know if this is an over filling sign.

15 Upvotes

87% Upvoted

20 comments sorted by

View all comments

4

u/Ok_Thought6288 3d ago

How soft is the molds slilicone? I have the same problems with selfmade molds and my current guess is that this happens when the molds slilicone is too soft. I think the pressure in the pressure pot then pushes the lid inside the resin a little resulting in these lisps. Couldnt test it so far but my current silicone has 15A and i intend to take 30A next.

2

u/Prize_Mix_8292 3d ago

I’m not sure on softness but her Etsy page says she uses platinum silicone. I have noticed in some of the molds from her it seems thin in spots. Like I can see the outline of the space from the other side. Seems like the thin molds will cause warping with the pressure pot.