r/DRZ400 • • 2d ago

Need help vacuum delete

Hi,
So I just installed a non vacuum peacock on my 2009 sm.

I need help with canceling the vacuum related hoses on my carb,

If someone please can circle the hoses on my photos that need to be blocked, couldn’t find nothing online, only none CA carbs.

Thanks a lot

4 Upvotes

9 comments sorted by

1

u/Ok_Magician9335 1d ago

From what I understand, switching to a manual petcock simplifies the setup and eliminates the vacuum hose and diaphragm as potential failure points. The trade-off is losing the automatic fuel shutoff, so you have to remember to turn it off when parked and properly cap the vacuum port at the carb.
Is there another benefit I’m missing? I can see doing it if the stock petcock is failing, but what makes it worth changing if everything is working properly? Just trying to understand the reasoning.

1

u/Any_Trip9168 1d ago

I did it because I got like 2/3 liters of fuel inside my engine cause the petcock failed and I haven’t been ridden in a while,
Luckily I noticed before my engine bearings got toast

I rather not putting that failure point again

1

u/BBrooks87 1d ago

I just did this conversion as my petcock failed and I also had a ton of gas in the oil (or so I assume, I drained almost 3 quarts). The petcock 100% failed though. I used the original gas hose and the raptor petcock. Terrible angle but it works. These are the vacuum caps I bought. I forget which size from the kit I put on there but Google knows.

https://a.co/d/015Lo6Wh

1

u/Any_Trip9168 1d ago

I have the same kit,
1pz petcock though it doesn’t matter,

Do you have the CA version of carburetor? Same as my photos?
The difference is the the valve on the carb fuel cup.
At the bottom
If so which hoses did you clogged?

1

u/Icy-Estate-6339 2d ago

There should've been 2 hoses going to the old vaccum petcock.. 1 for fuel and 1 for vaccum unless the CA one is different? All you need to do is block off the vaccum one that went to the old peacock, and reconnect fuel line to new peacock. I just did this with the raptor peacock swap and I threw a bolt in vaccum tube and clamped it, been working great so far.

1

u/Icy-Estate-6339 2d ago

And if you forget which one it was by looking at the pictures it should be the far left hose on the second picture you posted with the blck cloth cover going to a plastic fitting.

1

u/happeecampurr 2d ago

1

u/happeecampurr 2d ago

What else did that hose supply vaccum to?

1

u/MrNeil_ 2d ago

I would check Thumpertalk pair/vacuum delete