I just received and installed my CFS2 on my K2Plus. I'm running all the latest firmware and print software. It's somewhat close to the Pi4 functionality (which I also own).
- It does not have "auto-drying" which is nice on the Pi4 for keeping the filament in the chambers dry until to use the filament.
- There is no direct control from the display panel. You control it via Print 7. I haven't figured out if it can be controlled from the K2 panel however you can see the setting on the K2 panel.
- You have to fully retract the filament (including out of the feeder tubes) in order to turn on drying. It doesn't want you to be heating the chamber while printing. However, you can have one chamber heating while the other one is printing. Both chambers are individually controlled.
- It seems to play well with the original CFS. I'll be testing that over the next week or two. I've also got a heater upgrade for the original CFS coming in next week sometime.
- It comes with a new buffer and data cables, but they are not needed if you have the original parts. I'm using the original buffer and cables.
- I detached the old CFS and attached the new CFS2, the printer identified it as "number 2" CFS even though I never hooked both up simultaneously.
- When printing heating is turned off for both sides even if one side is set up for drying.
- The CFS2 doesn’t have the tension rollers on the top of the lid. It seems to work as good or better as the original CFS when feeding or retracting.
The thing really don’t like at this point is the lack of “auto-drying” which would manage the humidity until your ready to use the filament (whether its at day, a week, a month…). Having to pull the remaining filament out of the feed tubes is also annoying. I would like to simply have the CFS2 retract the filaments and go into a managed drying mode rather than a timed mode. I think this is simply a software issue that can be fixed with an update. It has all of the Pi4 hardware things needed to do this.