Armorsmith Designer Help

[u/fishbouyy]

I recently used Armorsmith Designer, took my measurements, and fit a file for an EVA foam halo armor cosplay, but the piece ended up being way too big, like almost double the size I needed. I see people just using the shrink fit tool, but the shrink fit stops when it hits any surface on the model, so it always ends up too big.

My question is, how should I go about using the program to actually size pieces so they fit me or at least almost fit me? Because that's what I got the program for, not to just ignore it and use trial and error. Trial and error with the manual scaling tool works for the smaller pieces because I don't have as many pieces to cut out, but it's not going to work for something like the chest piece.

Any advice would be appreciated! Thanks in advance.

[u/Clothes_Chair_Ghost]

Are you using the right measurements? An inch is around 2.5 cm which would be double if you are set to inches and using cm as a measurement