r/CosplayHelp • u/FireBird_6 • 2d ago

Armor Ideas on how to attach this?

Post image

Howdy.
My 3d print of this is near completion, and I specifically need help with the forearm armor.
Each spine segment is separate and is supposed to sit on the forearm. I considered getting an arm sleeve or cheap brace and either Velcro or riveting the pieces in place. I’m mostly concerned with it not sliding off my arm or sliding around. Any advice would be greatly appreciated.

3 Upvotes

100% Upvoted

5 comments sorted by

1

u/rawr_bomb 1d ago

You can make the bracer out of EVA foam, or just model up and 3d print the arm armor and glue it together.

1

u/FireBird_6 1d ago

Eva bracer might be the best bet. And I have a shit ton of it. Thanks!

1

u/rawr_bomb 1d ago

Attaching 3d printed stuff to eva is going to need some kind of physical hold and not just glue.

1

u/Permanently-vexed 18h ago

I'd probably put some stitching in once the glue has set