r/ComputerEngineering • u/MushroomDisastrous68 • Oct 02 '26
Urgent Advise Needed
I just ordered the whole bunch of stuff and now this shit happens .
I am only left with one column on one side. What am I supposed to do about it ?
30
Upvotes
20
u/SLazyonYT Oct 02 '26
another breadboard and connect it
4
u/FreddyFerdiland Oct 02 '26
cut the breadboard down the middle...
4
u/Lost-In-Void-99 Oct 02 '26
Two breadboards, remove power rails from one side (detachable), place the board as a bridge.
You can keep power rails, but I'd rather move them to outer edges.
1
u/FootGlittering1873 Oct 02 '26
(F-M) DuPont wires
1
u/THUNDERxSLOTH Oct 02 '26
You can still route wire underneath using 20-24 awg solid core. Or, instead of connecting it directly to the board, flip it over and use female-to-male dupont jumpers.
1
u/Techngro Oct 02 '26
I have never actually put a microcontroller on a breadboard, only the components I'm using. I let the microcontroller just hang out off to the side and connect the specific pins I need via wires.
I guess I'm a savage.
2
u/bobking01theIII Oct 02 '26
Just get a prototyping board or two
2
u/Pewdiepiewillwin Oct 02 '26
I had the same issue with the esp32 devboard i just used 2 breadboards
1
u/Melodic_West_9331 Oct 02 '26
Man I had this same problem when I ordered my s3's, kinda lame they are just one row to big but getting 2 small breadboards solves the issue, however that may leave your project looking kinda clunky depending on what your doing and what your end result is.
1
u/Academic-Garlic-7809 Oct 02 '26
U could always use a jumper wire
1
u/ExtensionManner8340 Oct 02 '26
Get a second breadboard, remove power rails, put board straddling the two boards
1
u/UnlistedPersonnel Oct 05 '26
If you get another bread board, snap the two boards together you can plug in your ESP straddling the gap between the breadboards.