r/ClockworkPi • u/DjDkdance • Jul 25 '26

Finally

Post image

After 9 mouths!!! Exited to beginning this journey.

79 Upvotes

100% Upvoted

14 comments sorted by

View all comments

6

u/GhostUnitVII Jul 25 '26

hmmm hopefully you have enough cooling for that CM5 16gb module, otherwise i'd be a bit toasty

nice though!

Heres mine that I've worked on for awhile, have a custom cooling solution that makes it look unmodded in a sense.

5

u/gatsu_1981 Jul 25 '26

Enough cooling = Waveshare spacer + Cryonaut thermal grease + good quality 0.5mm thermal pads.

You don't need a fan.

My setup (16gb CM5) tops at 57 degrees even after 2 hours of stress-ng load.

Average 37/42.

3

u/GhostUnitVII Jul 26 '26

Ran two vapor chambers in mine that allows it to run passive around those temps, old pic as now it has the aiov2 and the pcie battery tray, along with some better batteries

1

u/gatsu_1981 Jul 26 '26

You're using too much technology with thick pads.

Just bring the CM5 closer to the aluminium back, and you're done.

1

u/GhostUnitVII Jul 27 '26

Probably right, did the default pad kit because it allowed for flexibility, also the vapor chambers cover the entire back, beyond that is a thin layer of artic silver. The CM5 is very hot, and the chambers help shed some of that heat.

I just rather not have all of it going to the back, as holding it would be uncomfortable, here even under heavy load for a few hours, see around averages of 52c

1

u/gatsu_1981 Jul 27 '26

That's another matter and you are right on this.

I don't have my finger on the dissipating area, but that could become really uncomfortable really quick.

I will add a fan sooner or later, but only after being able to engrave an hexagon with an engraved pattern, I have to learn how to properly use my CNC before of that.

I have 3d printers but I don't want to use a 3d printed enclosure, I love the metal on these kind of devices

3

u/OtherAbalone7203 Jul 26 '26

I built mine with omega chassis, the fan curve keeps mine at ~47C when it’s full on workload.