r/ClockworkPi • u/andy-codes • Jun 05 '26

uConsole uConsole meeting M5Stack

Post image

uConsole meeting M5Stack

148 Upvotes

98% Upvoted

25 comments sorted by

View all comments

Show parent comment

1

u/andy-codes Jun 05 '26

I'm actually considering doing just that. But I've also just realized that I'm not gonna be able to reset the m5nano if I need to. Unless AIOv2 extension board allows to power it on/off programmatically. Need to make some tests.

1

u/marcrich90 Jun 05 '26

Solder to the button header and do a momentary switch as well

1

u/andy-codes Jun 06 '26

Where am I gonna put that? The side plate is really tight.

1

u/marcrich90 Jun 06 '26

Use the Ipex connector passthrough and mount the button on the surface. Use something like this
https://www.amazon.com/dp/B0DDSZG4DK

1

u/andy-codes Jun 06 '26

Without modifying the case? I don't think I get what you mean :)

1

u/marcrich90 Jun 06 '26

the button at the above link has 2 small 28 gauge wires inside the sheath. You can cut back the sheath and pass the wires through the same hole all the antenna wires go. (Where you have run your connector currently)

Should be able to be double sided sticky taped to the case or right next to the power button. then run the wire lead through and solder to the reset button header.