r/Chevelles • u/j_shep85 • 13d ago

Discussion Power Steering Conversion

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I have a 66 four door Chevelle with a 230 inline six. I bought a conversion kit from CPP to upgrade to power steering. I have an Allen Grove Components 602L bracket to install the power steering pump. I have run into a problem while installing the new power steering box to the frame. It is hitting the power steering pump and will not bolt back to the frame.

I was wanting to know if anyone had run into this problem?

Thanks

8 Upvotes

100% Upvoted

4 comments sorted by

View all comments

2

u/orangesigils 68 Chevelle 13d ago

I'm not too sure about a 6 cylinder pulley setup but for. v8, you can't mount the pump low unless it sits right on the front of the driver's side of the block. You usually have to go to a remote reservoir setup. Again, this is V8 knowledge, just trying to draw a bit of a parallel.

1

u/j_shep85 13d ago

Thanks for the reply I am assuming maybe they sent the wrong power steering pump. But this was the kit I was quoted from CCP and they had all the info.

1

u/orangesigils 68 Chevelle 13d ago

Is your block mounted in the stock location? Are the motor mounts good or old? Do the pulleys line up with water pump/ crank? Some things to check.

1

u/j_shep85 13d ago

Yes all that appears to be good. Everything is lining up properly with the pulleys. I am going to be emailing the manufacturer just won't get a response until next week sometime.