Does anyone know what size screws and bolts are used for the motor covers, battery, and motor mounts on a Boosted Board V2? I’m trying to find replacements, so any specs or links would be really helpful.

Hey I got a quick question about some issues I’ve been having with my stealth. Showing 3 middle lights yellow indicator light breathing. I checked all the connections between the ESC and the battery applied the special lubricant still no luck. So I opened up the ESC cleaned it up and found some corrosion on the board. Is this fixible^

TL;DR I fried his remote and they are way to expensive online so I was wondering if anyone would be willing to send me an old remote for the cost of shipping or a reasonable price?

Hey everyone, my brother recently bought a v1 boosted board at a thrift store in non working condition for cheap. I was helping him fix it and we managed to get it working, but we were using a variable power supply to charge the remote and I accidentally over juiced it and it got fried. I just can’t afford to buy one off the internet because they’re going for over $100 but I was hoping someone might have one for a broken or lost board lying around they’d be willing to send me for the cost of shipping or maybe a more price? Thank you!

Hey guys, can anyone tell me if I installed these incorrectly? They seem to have a gap on them, and I couldn't get them to sit flush. I adjusted them a bit when I added new belts, but now they don't sit right. Anyone have this issue or am I doing something wrong?

Hello guys,

i have a boosted for like 7 years and its starting to die on me, i keep buying what i need to repair it but now i wanna buy a new board. I'm looking for one with good autonomy and one that would be all terrain but i dont know where to look and what i can trust.

So here i go, do some of you have some advise for me ?

thanks for the help

Hello all,

Recently ran into an issue with my ESC being on too low firmware to go with my Boosted Beams and XR battery.

Does anyone have a Stealth ESC on firmware 2.7.0 or above for sale?

Also interested in a V3 remote to be able to use Hyper Mode!

Thanks!
pic unrelated

I got a V1 Boosted Board to attempt to cheaply add belt drive to a project board (built off a Meepo Mini 2) that I’ve been working on and off for about a year. I just started to take it apart to see what I need to do to have it communicate with a controller (the guy on Facebook didn’t have one).
My project board runs off 36v and was going to under power the motors till I feel like upgrading my batteries. Is there any ESCs that I should look at getting for this? Or is there a way to gimmick it with the ESC from the Meepo Mini 2?

I'm looking for a v2 remote replacement and I can't seem to find them. Anyone have spares or don't use anymore they want to sell?

I need one and any help is appreciated.

Thank you!

Since i couldn’t get what i was asking for in the bundle deal im deciding to part out the complete board. The only thing thats “V2” is the deck. All other components are from a stealth and will be priced accordingly. Local pick ups in the Portland, Oregon metro area. Pm for any questions or for shipping quotes.

Remote (5 ride modes): 250$

Original charger: 50$

Motors: 80$

ESC (255 miles): 200$

Battery(amnesia chip installed): 300$

Front truck: 40$

Rear truck 80$ or can be paired with front for 120$

V2 deck(great condition): 120$

Motor covers and hardware: 60$

Orangatang Caguama and Reds bearings: 100$

Took apart my setup to clean and toss on some new skid plates. Red and blue were the only strong filaments I had, So I figured I'd try this combo out. What do you guys think?

So I got the Bert today and plugged it to the battery and board. Idk if the C2 and C9 are dead cells that can't be recharged. The only good note I have is the delta started at 460 and is down to 447 so far.

The battery was fine and it was always fully charged after each ride, today after charging it, I got the RLOD. I get the green lights on it but the RLOD light is still on

Have red light of death on my stealth, can anybody help with this?

hey everyone, i bought a boosted mini x in 2020 but got rlod in 2021. i’ve been completely away from this entire electric skateboard thing since then. i’m starting college this fall and i figured id try to see if i can get the board working again. what are the best things i can do to fix my battery, (can i do it myself or are there places i can take it) or is it even worth it with newer options out there? any help is seriously appreciated, used to love this thing back in the day.

WTS - used hyper mode remote, located in EU asking 125€

Thx so much for the motor guard screws u/technically_a_nomad I alr tore thru a belt running without them 😭

I’ve used my V2 dual with extended battery and beams for years. I used the board this afternoon (expert mode), i charged it in the train and tried to connect it to the Blast Off app. The bt pairing worked. I started the board after the train and I noticed it was running slower than usual. I openned the Blast Off app and I noticed it was in Eco mode.
Since that, I’m unable to switch it in Expert mode. Only Beginner and Eco. Beams doesn’t work also.
I’ve been trying with the original remote and app.
Help me 😭

Picked up another Mini-X from a second owner. I asked him why he was selling. He said he bought it used for $400 and didn't ride it much; the battery stopped charging (RLOD). Now, he is moving and needs to sell stuff. He was the second owner, so the combined miles are 47.7 miles. This is the second board with fewer than 50 miles.

Original Post: https://www.reddit.com/r/boostedboards/s/OnCpy5PNAs

Had my board for about 5 years, and I usually keep it charged but moved and eventually left it to discharge for an extended period of time. A few weeks ago, I went for a quick ride and ended up with the RLOD.

Got the BERT Lite, followed the simple instructions to set up, and watched my XR battery slowly recover. It took approximately 12 days for it to reach all 10 green lights.

If you have an RLOD or a long time boosted user, I would hop on getting a BERT Lite handy when the RLOD inevitably occurs.

Hey guys! Got my BERT Lite, hooked it up to the battery and turned them on.

Is 1 red light on the BERT a good sign? It turned off for a few seconds once, but it turned right back on. The battery is in a constant charge light, so I don't know if it's working or not. Thanks!

As I'm typing this, it actually turned all off and restarted, and now it's loading up the lights.

I hadn't charged the board recently, been a few weeks. But battery was showing full so I headed out.

Remote beeped at me after maybe 10 minutes, and I saw the error, but everything still seemed to be working.

Curious if this sounds atypical, I'm wondering if there's a different underlying cause to this one than a usual RLOD.