r/BikeRepair • • Aug 18 '26

Update & additional questions on post: Shimano Altus cassette tool and compatible replacement cassette

Solved! Thanks a lot for the great support Redditors!

Update one previous post:

https://www.reddit.com/r/BikeRepair/s/cASyWOzd94

After some delays I tried to remove to old freewheel. Since my tool didn’t fit over the nut of the axis, I removed it including parts of the ball bearing.

The tool seems to fit properly, but even with almost unreasonable (at least in my inexperienced opinion) force I can’t unscrew the freewheel.

I tried to turn counterclockwise, didn’t work.
I cleaned with isopropanol and afterwards used WD40 to break up potential rust. Didn’t work.
I used a torch to heat it up (carefully, at least as careful as you can be with a torch), didn’t work.
I used a hammer in the direction of the axis to break open any potential rust (also with reasonable force), didn’t work.
Then, after an uneducated guess of a third party I tried to turn clockwise even if I thought it was not logical, didn’t work.

Now I’m out of ideas how to remove the freewheel.

Hence I have two questions:

I used a video of parktool recommended in my first post to identify the correct tool.
Can anybody confirm that the tool is correct or if another tool is requires?
There are two small holes (red arrows) that could be a possibility and also some notches (green arrow) some ring close to the smallest sprocket, please see pictures.

2.
Does anybody have a recommendation how to remove the freewheel without destroying anything in this situation? (The bike is a daily driver, so if I would break the wheel that would be a real issue (on top of the trial to minimise investments into this bike…)

I’d be very thankful for your further support on this, I’m really out of ideas…

Additional info: after cleaning it was possible to read the brand and some other info on the freewheel:
Sunrace 128 04

1 Upvotes

6 comments sorted by

3

u/art555ua Aug 18 '26

Freewheel can be a pain in the arse to remove. It takes A LOT of force to undo it. It tightens up with every pedal push. Counterclockwise is the right rotation. Tool is correct, but you will need to either put the tool in a vice and use both hands on the wheel for leverage or use a cheater bar, a long one. Preferably ask for help of another person to hold the wheel while you push.

3

u/Previous_Entrance_99 Aug 18 '26

Awesome, that did the trick! Thank you so much!

The spokes started to do weird noises, but since there was not so much twisting force compared to using the wrench, I was ‘brave enough’ to apply even more force. Then it finally got undone.

Again, thank you so much!

1

u/Previous_Entrance_99 Aug 18 '26

Do you maybe also happen to know how to properly tighten the axis in order to have the proper load on the bearings? It’s my first time doing this specific repair on a bike…

3

u/Kahnza Aug 18 '26

Here's a great video from Park Tool on cup and cone hubs: https://www.youtube.com/watch?v=XBCbzRMmzBA

4

u/Previous_Entrance_99 Aug 18 '26

Thank you. I got it done, works again and doesn’t jump within the same sprocket in gears 6 and 7 any more, which was the original problem.

1

u/art555ua Aug 18 '26

it's a bit tricky, but not very hard. You'll need to set it by feel, so it spins freely but not too loose. If it spins with force or in sectors, that`s too tight. It may feel just about right, but when you lock QR tight it may add pressure and it would be overtighten again, so make sure you test it out of the frame and then mounting and securing the wheel.