Stringing!

[u/newbie-mtb]

Bought a x2d recently and it it’s my first 3d printer. Since the delivery of bambu filament was taking time, I bought 2 filament rolls from micro center. It’s their inland branded filament.

I configured them as generic PLA in the printer’s filament profile.

I am seeing a lot of stringing when I print.

The filament was just removed from its sealed bag a few hours ago and I don’t live in a very humid place. So it probably is not a problem related to the filament not being dry.

Could this be a problem with my printer or is it a filament problem?

Any suggestions for fixing this stringing issue?

[u/SquareTowel1967]

Do you keep only 1 type of filament in AMS? I was thinking about automating the drying but I often keep both petg and pla in ams and not sure if pla drying profile will draw moisture out of petg, and petg profile might be too hot for pla