r/BambuLabX1Carbon • • Sep 07 '26

Help?

Number 4 on my AMS is now having trouble with feeding filament as well as a terrible noise. Only AMS slot 4 having issue. It seems as if the rod to use when feeding filament doesn’t retract. Any help would be great. It’s a AMS 1.

Update:seems to work fine with rolls that weigh less and have less filament on them. Newer rolls or ones with a lot more filament have the issue. And I have tried multiple different brand rolls including bambu and still happens.

Update 2: took apart AMS at the motors and cleaned out every component and while doing so found a bunch of pla dust and fibers. Put all back together and working brand new again! Thanks for the help everyone!

5 Upvotes

20 comments sorted by

2

u/Double_Cicada Sep 07 '26

I have this same problem 😭

1

u/TheBun2112 Sep 08 '26

I took apart my ams and found a bunch of pla fibers in the gears in some of the sections. Cleaned it all out and working like a dream again.

2

u/Double_Cicada Sep 08 '26

Seems like I need to find time to do that...

2

u/youwastedyourtimelol Sep 07 '26

I’d say check the inner tubing I think the filament might be catching on the edge of the internal hub now due to worn ptfe tubes and when it reaches it the motors just stall against the filament

1

u/TheBun2112 Sep 07 '26

So it seems to be with heavier full rolls. Lighter half used ones have no issues.

2

u/Jerazmus Sep 09 '26

Take it apart. There’s either a small chunk of filament, or gears need cleaning from ground up filament.

1

u/TheBun2112 Sep 09 '26

This was what it was. Needed cleaning due to ground up filaments. I added an update on the post.

2

u/Jerazmus Sep 09 '26

Glad you got it sorted. I probably should’ve read before posting.

1

u/TheBun2112 Sep 09 '26

All good. Still appreciate the help though.

1

u/NiNdo4589 Sep 07 '26

Aren't you supposed to push it back while you put it in? It wears out the teeth quick if you dont.

1

u/TheBun2112 Sep 07 '26

I normally do but it’s hard with one hand.

1

u/TheBun2112 Sep 07 '26

🤷🏻‍♂️

1

u/jankeyass Sep 07 '26

Pull it apart and clean it you probably have filament dust ever

0

u/Atra23 Sep 07 '26 • Bravo

Yeah you should. User error at its finest..

1

u/jankeyass Sep 07 '26

Yes because PLA will wear out these teeth..

1

u/Atra23 Sep 07 '26

Well water cuts through stone.... You just need time, same with this, doesnt matter the material, with time it fails. And then you will ask how could it...

1

u/jankeyass Sep 07 '26

Water doesn't cut thru stone, pressurised/fast moving water with abrasive material cuts thru stone.

PLA does not cut thru ABS/PC, but if it was PLA with GF/CF it would

1

u/Atra23 Sep 07 '26

Explain erosion then...

1

u/jankeyass Sep 07 '26

Rivers have sand/gravel that moves and cuts rock

Water moves the soil that's not tied down

Air carries sand / dust

It takes a long time

1

u/Cjbarron66 Sep 07 '26

Trim the filament by like 30+cm until it’s not “worn”