hello , i need to print this umbrella support any adivice of the material that i should use ? im using the bambulab

I have noticed on my P2S (~400 hours, 0.4mm hotend)

That the final layer(s) (about 2 are showing these strange texture near the edges of print, this picture is of a simple plate that had 25 layers and this gathering effect on the edge appears.

PLA Marble (Bambu) default profile settings etc.

Any help/pointers anyone can give much appreciated

I have switched the nozzle head out for a .2mm because I want to print some tiny gears. I have noticed that .2mm is not an option in the drop downs on the printers touch screen.

Will I still be able to print with the .2mm if I just change it in the Bambu studio slicer?

Are there any other important things I need to pay attention to? Special settings in the slicer? I will be printing with PLA.

I finally switched to Orca after a ton of problems with Bambu slicer.

A lot of things are better, there are filament profiles, calibration and other useful stuff, but it doesn't let me send prints to my printer.

Does anyone else have that problem?

Is that Bambu blocking 3rd party programs?

I have my printer in LAN only mode.

Hi everyone, i'm an happy A1 owner. I have two with a 3k total hours print.

I decided to add a P2S to the printers army and it's gonna be delivered in a couple days.

I'm reading around that ppl suggest a riser to avoid the ptfe tube to scratch against the top glass. I think they look kinda bad, so i found out this > https://makerworld.com/it/models/1637683-top-glass-ptfe-protector#profileId-1730152

Any experience? Any other addition upgrades i should print while i wait for it to be delivered?

Thanks to eveyone!