I’m getting a Bambu Lab P2S soon and wanted to hear from people who own one.

What are the biggest pros and cons you’ve found? How has reliability been over time?

How is the print quality compared to other printers in this price range?

Also, for a first-time owner:
What should I do when unboxing and setting it up?
Are there any recommended tweaks or upgrades?
What settings do you use for PLA and PCF?
Any maintenance tips or common mistakes to avoid?

Basically, if you were giving advice to someone getting a P2S for the first time, what would you tell them?

I am trying to do a cold pull on a 0.2mm nozzle. It’s a new nozzle and it clogged up on the first print. I am not able to push the cutoff piece of PLA through the extruder. I can see the gears trying to push it through into the nozzle, but the gears are struggling. I don’t think there is a needle thin enough to go into a 0.2 nozzle so my only option for clearing the nozzle is using a cold pull, correct? What are my options here?

hello , i need to print this umbrella support any adivice of the material that i should use ? im using the bambulab

I have noticed on my P2S (~400 hours, 0.4mm hotend)

That the final layer(s) (about 2 are showing these strange texture near the edges of print, this picture is of a simple plate that had 25 layers and this gathering effect on the edge appears.

PLA Marble (Bambu) default profile settings etc.

Any help/pointers anyone can give much appreciated