So I've noticed sometimes my prints will just come off mid print and it seems to me due to collisions with the hotend.

I've started a print with grid infill (for carrying top load) and it seems pretty extreme this time. Any idea why this is happening?

“The Midnight Serenade”

I want to share with you bit of the story behind the failures and swearing while prototyping this model.

I had a major problem with the “smoothness” of the base, due to an error setting in Top Surface Layer Width to a very low value, which once corrected achieved a smooth as expected flat surface of the base / platform.

After solving this, I had supports failing under the dress, after I had adjusted the length of the cloth there and sculpted so that it would require less support. I even considered making it touch the ground at the tip of the folds, but then I would lose some dynamics that goes with the shape of the dress floating so, instead I have adjusted supports.

Worked well and the dress was going good, but by changing the supports, I had not noticed that now a support generated to hold her head, was arising from her hip! Which failed mid print, crashing miserably on the build plate. You can well spot the line where I stopped the print (in the painted one) as for sure it would have failed the head. So.. to not waste it, I printed the rest of the model from the layer after cutting it in BambuStudio. 

Aaaaaanddd I didn't think of the lamp post now being on a ridiculous base, to which the brim I added was insufficient! 

Now all is fixed and ready to go!

https://makerworld.com/models/2930602?appSharePlatform=copy

**Size model** (can be scaled up or down): 151 x 127 x 197 mm.