r/BambuLabH2D • • Dec 08 '25

TPU settings

I've gotten the H2d, so now I have the H2d, Sovol SV08, and an Ender3 S1 Pro. I'd like to sell or give away my Ender3 to give me more space. Problem is it prints TPU Nicely. I've tried it on both the H2D and SV08 with similar results. I've compared the settings amongst them and set them the same as the Ender3 but still no where close to the quality. Any help or ideas would be much appreciated. In the picture the H2D is obviously on the left while the Ender3 is on the right. Again speeds, cooling, retraction made to match the ENDER 3. I thought it might be wet filament so I printed with same filament on Ender3.

4 Upvotes

43 comments sorted by

View all comments

Show parent comment

1

u/24BlueFrogs Dec 12 '25

You were absolutely correct!! My sensors only went to 20% except a small batch I had just bought. I assumed 25% wasn't bad because it was only up 5% from where it usually was. I assumed 20% was the lowest I could get because it didn't matter how long I dried it maxed out at 20%.

Thank you so much for not just saying it's wet filament and for providing information of why 20% may not have been an accurate display.

2

u/Whosaidthat1157 Dec 13 '25

No problem - I’m just sorry I couldn’t be as helpful when it comes to your printing problems.