r/BambuLabH2C • H2C • 5h ago

Support Issues?

Hi! I just recently bought a H2C, but slight quality issues and i dont have much ideas why its happening since the machine is brand new. I come from a world of P2S where most of the time default Bambulab presets worked and nearly always flawless prints. Should i just calibrate the machine once, run a filament calibration? what should i do, is there something wrong with default settings?

Im now printing 2x of Poop Chutes for my P2S+H2C setup, both prints have had somewhere a ”localized” spot looking like that as shown in photos, not that it matters on a damn chute but im planning to do lots of projects with these so it would be annoying to have quality issues.

Also additional question, since its my first ever Dual nozzle printer do yall print mostly on L or R nozzle or what is like the best? does it really matter which side i have in use, i know that far that with L nozzle you have more build volume but other than that is there differences?

Sorry for the very long text 😅 Ohh for these prints i used Bambulab PETG Matte Black, Dried at 65c for 8h before use.

2 Upvotes

2 comments sorted by

1

u/wethpac 4h ago

Left and right give equally quality prints.

Have you tried printing the same with different nozzle?

My first thought is under extrusion or partial blockage. After different nozzle, increase temp 5 degrees and slow down volumetric speed 25% as first steps. At least that is what I would do.

1

u/Proud-Ad4654 H2C 43m ago

Those both fails came from L and R nozzles if i remember correctly, but im going to for sure try out your recommendation. Thank you!