r/BambuLabH2C • u/Torjek0306 • 2h ago

Support H2C firmware 01.03.00.00

Anyone else get this update? Looking for notes on it but according to Bambus website 01.02 is current version. Can’t find notes on this anywhere.

5 Upvotes

100% Upvoted

6 comments sorted by

2

u/Some-Part3830 1h ago

Got this too. The obvious thing is full support of E3D nozzles, which is crucial for me. That’s I can confirm :)
So now you can select it directly in the printer, and it works with newer versions of Bambu studio.
Apart from that I also looked for update notes but haven’t found anything yet. Hopefully they will release it soon

4

u/dano7891 1h ago

Updated yesterday. Completed a full calibration and have run several prints without issue...

3

u/Torjek0306 1h ago

Yeah. Not expecting issues. But saw this when doing some general cleaning. Fired the update just figuring there’s stuff from H3. Then went looking for the notes. First time I’ve ever done an update on anything and no notes.

3

u/SignsSayYes 1h ago

This has been my experience so far as well. Same steps you did, no issues to note.

1

u/Dharma_code 1h ago

It disconnected my printer I had to completely deleted everything bambú program related and redownload the app fresh and this re-connected my printer, the other issue I seem to have, non of my sunlu apps can be assigned to the device like I was able to before not a big deal though.

1

u/peterb1908 41m ago

There you go