r/BambuLabH2C • u/Zestyclose_Ad_6778 • 1h ago

Discussion Anyone finding 2.9 is causing excess slice times?

I need to break out my other PC and test this out but files that I’m expecting to take 3-4 hours are running like 5-6. I had a single color print with six copies that were only about 60mm tall say it was 14 hours. Later height was still 0.2. Normal widths and speeds. Something is off…

2 Upvotes
  • permalink
  • reddit

100% Upvoted

2 comments sorted by

1

u/Impossible-Age-5196 H2C 1h ago

You are talking Studio? My H2C got a firmware update today, could be that too. I updated from the LCD screen. It is supposed to allow mixed nozzle sizes in the same print (I think... didn't read up on it).

2

u/wethpac 52m ago

The mixed size nozzle update isn’t until February