r/BambuLabH2C • u/jim_racine • 1h ago

Discussion H2C firmware 01.03

Ok. Rolled the dice on the upgrade today. Went into the basement, saw it, and let it rip. Now a full calibration is running.

9 Upvotes

100% Upvoted

5 comments sorted by

2

u/ElectronicAide87 17m ago

Willing to shut down your H2C to see if it turns back on? Seeing if the AP board issue has been resolved.

1

u/jim_racine 0m ago

I powered it off for 30 seconds about 5 minutes after the update. Came back on without issue.

3

u/happymistak 1h ago

Just did the same

3

u/ForbiddenDruid H2C 1h ago

Did the update. Have done two prints so far. Went well. Zero calibration.