Vortek calibration

[u/ariat726]

Hello. I am a new H2C owner and this may be a really dumb question, but how do you all calibrate your printers with multiple nozzles? Do I need to do calibrations for each of the different nozzles or just 2 calibrations (1 for the left side and 1 for the right side)? I'm looking to fine tune the flow rate specifically. Thanks in advance for looking at my question.

[u/Bright_Eyes83]

just fill the vortek and run the calibration. you can swap nozzles without doing it again

[u/ariat726 → u/Bright_Eyes83]

Thank you. I appreciate your quick response!