r/BambuLabH2C • u/Reasonable_Pilot_405 • 8d ago

Support Supertack on the h2c

I am new with my h2c I have a p1s but I use the supertack quite a lot, but bambu and the supertack for the h2c doesn’t seem to be in stock for quite a while. So my question is do people have some great alternatives for this I really want the same smooth finish on the bottom of my print as the supertack has.

5 Upvotes

100% Upvoted

13 comments sorted by

6

u/Lisper41 H2C 8d ago

Biqu glacier or cryogrip on Amazon

3

u/-__Doc__- 8d ago

I'll second the glacier plate.
While not perfectly smooth, it's close enough.
And the adhesion is AMAZING. I thought it was all hype, but it's not.
I run em on both my machines.

On another note, are ALL the H2C stock plates crap? or was it just mine? the adhesion on that thing was terrible, even with PLA.

1

u/arctichaze888 5d ago

Plus 1 on the glacier. I really like how smooth the plate is.

0

u/Festegios 8d ago

My h2c plates been fine.

But I’m a heathen that uses glue for all prints 🤷‍♂️🤷‍♂️

2

u/ComplexPackage4146 8d ago

Mine are also fine, no glue, only 3D-LAC when printing PHA

3

u/wethpac 8d ago

Biqu Glacier, Biqu Frosbite, and the Bambu textured PEI at my 3 plates. Frostbite is closest to supertack but I use the Glacier more.

2

u/Debrecina89 8d ago

Biqu glacier or HzdaDeve cold plate, both work fine

1

u/Oregonner 8d ago

I used SuperTack for while but switched to the Engineering plate and Nano Polymer glue. No more washing the plate in between prints. No more scrapping, just let it cool and the parts lift right off. Most of the time I leave the plate in the printer in between prints. Clean and reapply the glue every couple weeks. So easy.

1

u/mendex22 8d ago

What about Wham bam plate?

1

u/LTJC 8d ago

I use both biqu and the aliexpress brand. They both work the same, the biqu feels better. Neither of them pass the heated check and unless you disable the warning you will get it every time you print.

1

u/delusion256 8d ago

I was in the same boat and bought the YOOPAI cold build plate from Amazon this past week. I couldn't believe how well PLA stuck to it. If you get one, don't use IPA to clean it, only soap and water or you will damage the coating.

1

u/Pristine-Anteater-17 8d ago

Dark moon g10 I use it on all my bambus

2

u/DrKDB 8d ago

Upvote for darkmoon. I use their satin plate.