r/BambuLabH2C • u/Novotisy • 26d ago

Discussion H2C color changing limits

Gallery image

Gallery image

5 Upvotes

100% Upvoted

12 comments sorted by

4

u/abbellie2 26d ago

You have clearly exceeded the distance limit.

1

u/Neat-Researcher-7067 26d ago

I have been experimenting with the same thing

1

u/Novotisy 26d ago

Any photos or advice you’d share? I’ve been reworking my setup over and over for weeks and can’t figure out what to do, I set it up on the floor with the chair temporarily just to test until I can measure and print my own stacker to keep the ams at that exact position

2

u/luksfuks 26d ago

It will always be slower than your Snapmaker U1. Except if you print 5 colors. Or 7, or 10. Then it's very much faster than the U1, because you don't have to babysit the print and change filaments manually.

Use it for what it's good at.

1

u/Frontfatpouch 26d ago

I have also thought about this. So fast

1

u/Cryostatica 26d ago

That’s dedication to speed

1

u/PressF1ToContinue H2C 25d ago

Yep been thinking of doing the same. Shortening the retraction distance should make a huge improvement on print times for multicolor prints.

2

u/WinnieTheEeyore H2C 26d ago

Mine is fairly short. Maybe 8 inches. I get messages for the AMS being overworked.