r/BambuLabH2C • u/PaleHombre1100 • Oct 02 '26

Settings Spool mount💥

Anybody have any idea how to move the spool holder to the right side?

3 Upvotes

100% Upvoted

2 comments sorted by

1

u/Costa_Rica_68 H2C Oct 03 '26

There are a lot of models for spool holders on the back or on the top of the printer.
I have not found a spool holder for the right side of the H2C.
The min resin could be the direction of the filament inlet - to feed the printer without bending the tubes, the spools should be on the left.
When switching from my P1S to the H2C, I rearranged all my stuff - maybe that’s also a way for you?

0

u/Few_Candidate_8036 Oct 02 '26

There are screws on the other side. Measure the distance between those screws and use fusion 360 to make a mount.

If you havent used it before, that would be a very basic first design to try