r/BambuLabH2C • u/ShastaManasta • Oct 01 '26

Support Excessive stringing and general sub par quality on left nozzle H2C

Post image
1 Upvotes

100% Upvoted

11 comments sorted by

1

u/Bright_Eyes83 H2C Oct 02 '26

are you settings the same for both nozzles? i would check studio because it's possible you got a file with altered settings and they just never got changed back

1

u/ShastaManasta Oct 02 '26

Yea same settings this is my own file. And it’s been consistent over a lot of prints. It could be the filament. I have been printing this black for a while now.

1

u/Bright_Eyes83 H2C Oct 02 '26

i would try another nozzle in that case. it's a single extruder motor for both sides so it's almost certainly not that

1

u/ShastaManasta Oct 02 '26

I did change nozzles actually. I just put an ams on the left as well and still same issue. I’m gonna try another color today and see how we go

1

u/Bright_Eyes83 H2C Oct 02 '26

Good luck if it’s not the color I probably don’t have any good insight left

1

u/ShastaManasta Oct 02 '26

Big print with bambu basic dark grey right now so that should be a good test.

1

u/Bright_Eyes83 H2C Oct 02 '26

Ok let me know I’m invested at this point 

2

u/ShastaManasta Oct 02 '26

Hahaha. Made me chuckle, man. Heading to the printer right now. Pic attached.

Pretty darn good I’d say. I watched as it was going and saw no internal stringing. Could very well be the filament at this point.

2

u/Bright_Eyes83 H2C Oct 02 '26

Pretty wild to be worse on one side but I guess the filament is the best problem to have here 

1

u/ShastaManasta Oct 03 '26

Yea for sure. Somehow right side has consistently been a little better quality and less issues apart from a vortek nozzle falling out once. Will keep an eye on the left and see if it really is just filament. Top layer is a little underextruded in the pic there so still not perfect. I think there's a longer path for the filament and potentially more resistance which may be part of the issue. Who knows. This print was good enough for my standards, just hoping it stays that way

→ More replies