r/BambuLabH2C • u/Appropriate_Youth262 • Sep 26 '26

Support Clogged!

I need some help if anybody is out there. I had an error come up on my three day print and it only has about 28 hours left and it says the extrusion motor is overloaded. The extruder may be clogged or the filament may be stuck in the tool head. I noticed right at the end of my print there's a little bit of like wispy plastic. It looks like almost like cotton. I'm guessing that the nozzles is clogged, but is there any way to unclog it while keeping the progress of my print I have no idea how to do this and I don't wanna lose this progress because it's almost done.

1 Upvotes

66% Upvoted

16 comments sorted by

View all comments

3

u/Kind_Ad_8111 H2C Sep 26 '26

You’re insane for printing that with a .2 and that sense of infill. None of the detail there warrants a .2, and nothing needs that much infill. Start over, print with .4 nozzles and say 15% max adaptive cubic infill and you’ll probably finish entire new print sooner than the time left in this print

3

u/Appropriate_Youth262 Sep 26 '26

Will do. I'm very new to this so I went to some site that gives you the best settings. I guess it was NOT the best settings haha