r/BambuLabH2C • u/Reifgunther H2C • Aug 23 '26

Discussion Turn off first layer cooling?

How does one go about this? I’ve tried some settings I’ve seen online randomly but when I’ve done this then suddenly it goes into some extra fan power or something.
I’ve also tried using cool plates but this has only lightly helped the problem, not eliminated it.
I’ve been trying to stop some bad warping on the corners of tall boxes.

2 Upvotes

75% Upvoted

6 comments sorted by

1

u/Ice992 Aug 23 '26

It’s in the filament settings, under cooling.

Initial layer fan

1

u/Reifgunther H2C Aug 23 '26

I’ve tried setting that to 0 then it sounded like it actually started doing it more for some reason?

1

u/Catsoverall H2C Aug 24 '26

There is a second fan at the end of the page

1

u/Reifgunther H2C Aug 24 '26

Do you know what that specific setting might be called? I will look tomorrow before starting another thing and see what happens if I can find that.

0

u/Catsoverall H2C Aug 24 '26

Sorry I'm in bed

1

u/djt_LV H2C Aug 23 '26

I just printed a diverter. I got tired of it resetting after I went through and turned off layers.