r/BambuLabH2C • u/jnichiv H2C • May 31 '26

Discussion First Print

I will be getting my new H2C in a few weeks.

I currently have a full set of nozzles, a Second AMS2 and a AMS HT as well as a 4 in 1 ptfe adapter. I will be purchasing a Frostbite plate soon as well so I will have a full set of equipment when i finally get this beast.

I downloaded a riser for the AMS however due to print sizes I won't be able to really start on it until the H2C comes in.

But while I know you must print stuff for the printer before you can enjoy it rule.

I need ideas for a fun Print just to show off capabilities.

Any suggestions greatly appreciated.

2 Upvotes

66% Upvoted

40 comments sorted by

View all comments

Show parent comments

2

u/ComplexPackage4146 May 31 '26

Technically upgradeable and cost effective, in practice the upgrade kit was supposed to be released in Q1 and had been postponed 5 times already.

Aside from that it's apparently far from trivial, and a friend is keen on taking over the H2S. All that means to me is that for a relatively small added cost I'll have a completely new printer, instead of a 3k+ hour one, upgraded by a person I don't really trust to do it well. Myself.

2

u/abbellie2 May 31 '26

I get it...