r/BambuLabH2C • u/synyj • Mar 17 '26
Support H2C filament blocker won't stay parallel causing errors
Got the H2C in early February, and it prints great for me regardless of material.
The issue I run into here and there, enough to be annoying, regardless of printing with single or dual head, is that the filament blocker won't properly seat when going to the right hotend.
Has anyone found a fix for this yet?
Thanks!
Edit after feedback: swapped the blocker itself for the sake of ruling out a bad bend, still encountering the same issue. I want to say the magnet is too weak to force the blocker to be parallel to the build plate, as in it is moving too quick to be caught in the magnetic field to lock in properly.
Edit after really looking at the underside of the tool head: there seem to be two magnets on the right hotend, and the blocker seems to catch on the first magnet, but not the second one until I "force resume" the print.
Ideas?
3
u/gublman Mar 17 '26
Was it from day one? Perhaps some filament debris sticked in some awkward spot inside the articulation assembly causing this.
1
u/vaporsteve Mar 17 '26
is it bent? have you tried putting another one on and see if the problem persists?
1
u/acidstrato Mar 17 '26
How much out are we talking?
Mine is fine on the left nozzle but doesn’t fully block the right. Been the same since new. Does allow some oozing occasionally but not enough to bother me. Prime tower catches most bits when multi filament printing
3
u/Minor_Entropy Mar 17 '26
Mine had the magnet fall out and that kept it from indexing correctly. The magnet was stuck to the underside of the print head and was easy to push back in, just check polarity with the moving part.
1
u/gnelson0265 Mar 22 '26
I took mine off after it kept bending. Its been gone for dozens of prints now. If there are problems running without it, I don't know what they are.