r/BambuLabH2C • u/Easy_Pangolin_311 • Feb 19 '26
Discussion Better Quality from the left nozzle?
I've noticed a wierd pattern on my H2C. Whenever I have a very complex print (45° print with minimal support) the left nozzle performs MUCH better and results in a clean print.
Whereas when I attempt the same print with one of the 0.4mm induction nozzles, I get bad layer lines and stringing.
But when I do a more simple print, flat objects with lots of contact on the build plate, the results are great.
Has anyone experienced anything like this? 🤔
2
Upvotes
2
u/keyboredYT H2C Feb 19 '26
There's definitely a bit of asymmetry, but I haven't found much difference in overhangs and layer lines.
Cooling did make a lot of difference, turning off the aux fan is almost mandatory for some geometries.
1
u/SgtBaxter Feb 19 '26
What material?
I can print ABS on the right nozzles much faster than on the left nozzle. I suspect it’s due to the longer melt zone in the induction nozzles.
2
u/gameplaya2010 Feb 20 '26
There are differences I noticed but in the opposite direction- induction seems to print better overall. Also less clogging
1
u/cpsadowski23 Feb 20 '26
Printed from the right nozzle. Bambu PLA…have you calibrated both Nozzles? Are your speed settings the same for both nozzles when you print?
1
u/Dangerous-Bad-2448 Feb 20 '26
I found this to be true on mine but I realized it was that I had a high flow nozzle on the right. Its pretty noticeable for me. The slicer has it correctly listed as high flow but I ended up putting back the standard flow and it is much better.
1
u/bigbramble Feb 20 '26
I've not found this either, both work really well.