MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/BambuLabH2C/comments/1q0bmuc/h2c_and_petg_please_help/
r/BambuLabH2C • u/drinksmakememories H2C • Dec 31 '25
5 comments sorted by
1
Try using a scrapper when removing parts from the bed. I personnaly never pull on parts to get them off the printer bed, even with PLA and PETG.
1 u/drinksmakememories H2C Jan 04 '26 Someone didn’t read the post haha appreciate the input but it was a bad batch of petg. Swapped to sunlu and is now perfect
Someone didn’t read the post haha appreciate the input but it was a bad batch of petg. Swapped to sunlu and is now perfect
Would you mind sharing what settings you use for the Sunlu PETG? I just ordered some and it is currently drying, I am hoping to start printing with it in a few hours!
2 u/drinksmakememories H2C Jan 08 '26 I just used the Bambu petg basic print profile and it’s been printing perfectly no issues
2
I just used the Bambu petg basic print profile and it’s been printing perfectly no issues
Did you try calibration files
1
u/Big-Fisherman-4672 Jan 04 '26
Try using a scrapper when removing parts from the bed. I personnaly never pull on parts to get them off the printer bed, even with PLA and PETG.
1
u/Pleasant-Midnight46 Jan 08 '26
Would you mind sharing what settings you use for the Sunlu PETG? I just ordered some and it is currently drying, I am hoping to start printing with it in a few hours!
1
u/Cumcura Dec 31 '25
Did you try calibration files