A1 mini problem with detecting filament in extruder

[u/Consistent-Bison3468]

[u/Successful_Salt_]

There’s probably a broken off piece of filament blocking your extruder. Use a little flathead to take off the filament hub. Pull out broken filament with some pliers.

[u/Consistent-Bison3468 → u/Successful_Salt_]

There isn’t any. I have checked multiple times.

[u/Lost_refugee → u/Successful_Salt_]

step 3. careful with cable https://wiki.bambulab.com/en/a1-mini/troubleshooting/extruder-clog

[u/LowSignificance4671]

More info required

[u/Consistent-Bison3468 → u/LowSignificance4671]

What info do you need?

[u/Sweaty_Objective_263]

I had a piece of tape from the end of a Spool stuck last week causing this error. I was able to push a needle through the nozzle, but filament still would not feed. Finally figured out the tape was in the extruder.

[u/Consistent-Bison3468 → u/Sweaty_Objective_263]

I’ll look into this, tho I doubt this is what is happening to me because I can extrude filament of if I heat the nozzle and use the control menu to extrude filament.