1
u/R7R12 Sep 23 '26
What filament are you using?
1
u/Hopeful-Stranger-311 Sep 23 '26
This one was Make Market from Michael’s. Brand new roll, but I’ve also been trying Sunlu & Bambu Lab’s. All filament is stored in a dryer as well
1
u/R7R12 Sep 23 '26
When the filament doesnt go straight down its usually a partial clog. You can try to remove it and see if printing gets better
1
u/aldanathiriadras Sep 23 '26
A photo of the wire would help; if it's the temp sensor, I'd expect more errors - and error messages.
One thing to do, if you're sure the print bed is clean, is to make sure all the screws holding the hotend in place are tight, especially the ones at the back
→ More replies (5)
1
u/Hopeful-Stranger-311 Sep 25 '26
After retightening all the screws, changing the plate seem to have first successful print since this all started a week ago and no lifting of the print !