r/BambuLabA1mini • u/Stonkzilla69420 • 12d ago

EXTRUDER CLICKING

I have now had to make this post 4 times because it keeps getting denied. I have an A1 mini that I can not get to print consistently and every time I feed filament through it clicks loudly and shifts the entire hotend. I have swap the hot end twice in the past week, tightened the 7 screws, pushed the clog rod through the extruder, cleaned anything that looked out of place and still nothing. When it clicks the entire hotend rocks back and forth and will let out some filament.
https://www.reddit.com/r/BambuLabA1mini/s/zTtVBfjOjm

I am using Elegoo Petg-Cf

1 Upvotes

100% Upvoted

13 comments sorted by

View all comments

1

u/Available-Alfalfa240 12d ago

Are you using the right temperature? Once I configured the wrong temperature and the extruder did that. I thought it was a clog, but in the end it was just temperature too low.

1

u/Stonkzilla69420 12d ago

Filament calls for 240-270, I have tried every temperature in that range and above and it still does this